Got a bit done tonight, but still need to wait on the throttle cables before I finish up the motor wiring.
- Got the inline oil filter hooked up
- Tabs on the prop nut bent to lock it
- Bimini brackets installed and bimini put on (have to pull it out of the shed before I can actually put it up due to height
- Hydraulic hoses ran, but need to adjust the elbows on the piston so I don't rub through a hose (didn't have pipe dope out there, so will tomorrow)
- Got grommet installed in seat base where the power cables go from the battery switch to the console
- 2nd battery tray put in and all batteries hooked up
- EZ Fenders installed
(actually snapped a screw head off, but got it removed)
- Started running wiring conduit to protect exposed wired underneath boat
- 2 bumpers put on the ez fenders?
- Killed a big ass spider that could have probably helped me with the below deck stuff a month or two ago had I known he was around (no help then, so no use for me now)
To do tomorrow.....and sunday probably
- Run bimini light wiring and install light... drink a beer
- Adjust seastar piston fittings and install piston side of lines.....drink a beer
- Finish running conduit on expose wires.....drink a beer and take a piss
- Screw in clamps for under boat wiring to keep it tidy against the bottom of the deck
- Remove fence and drill hole for bimini light wiring to run up through fence and into bimini frame (not gonna be fun)...drink 2 beers and pee (broken seal)
- Install primer bulb for fuel line....drink a beer and pee (seal issue)
- Install steering wheel.....pee / beer again
- Fill oil reservoir
- Prime fuel and oil lines
- Start motor??????
- Celebratory beer
Tuned......this order of things seem better?