Toonmate flush mount for the Toonmate table pedestal.
Posted: Sat May 20, 2017 8:35 pm
Just a heads up:
I bought a Toonmate table kit from Overtons a couple weeks ago, installed it, then both the wife and I kept stubbing our toes on the standard raised pedestal mount on the floor.
So, last week I ordered the flush mount; same brand, on the same page on their website.
When I received the flush mount base; the pedestal (stainless tube) wouldn't fit into it.
I called them, and they were very prompt in sending out another, and didn't even want me to return the first base.
Very nice; but the replacement one wouldn't accept the tube, either. I made it fit by removing material from the outer edge of the groove in the mount with a 1/4" bit in a drill press, then rotating the fixture "round and round" by hand.
Also, both mounts were packaged and marked identically, but neither were identified as a "Toonmate" part anywhere on the packaging.
I bought a Toonmate table kit from Overtons a couple weeks ago, installed it, then both the wife and I kept stubbing our toes on the standard raised pedestal mount on the floor.
So, last week I ordered the flush mount; same brand, on the same page on their website.
When I received the flush mount base; the pedestal (stainless tube) wouldn't fit into it.
I called them, and they were very prompt in sending out another, and didn't even want me to return the first base.
Very nice; but the replacement one wouldn't accept the tube, either. I made it fit by removing material from the outer edge of the groove in the mount with a 1/4" bit in a drill press, then rotating the fixture "round and round" by hand.
Also, both mounts were packaged and marked identically, but neither were identified as a "Toonmate" part anywhere on the packaging.