Pontoon Boat & Deck Boat Forum

Inside the center tube are a pair of flat synthetic boards that ride in some aluminum struts for support. The struts work loose from the adhesive that binds them to the inner walls of the tubes. This causes the boards to shift and knock the crap out of the bilge pump at the rear. What type of adhesive would you guys recommend to fix this irritating problem? The original looks like hot glue???

i'd probably try a hi-end construction adhesive, just the better tube from home creepo.
clean the aluminum with a good strong chemical first.

actually i'd have my buddy weld them on, but that's a different story.

I agree, liquid nails would do the trick... Gorilla glue works great too but it makes a heck or a mess!

Epoxy resin.

Hey Drago, did you ever make it out to Travis?

get some F26 , chit will stick anything

dog,

We're going to do that trip in late summer. Send me a private email over at oortdrako
and the rest of that is a yahoo thing dot you know what.

Thanks for the replies. I contacted Leech Products on the f26. I tried epoxy but it did not hold even after cleaning the aluminum.