Page 1 of 1
Easy Wiring for a Perko Switch
Posted: Tue May 18, 2010 1:04 pm
by pepper1126
Just bought a Perko switch from Bass Pro, can anyone out there tell me what else I need like wires, etc and how to wire the whole thing up, thanks?
Re: Easy Wiring for a Perko Switch
Posted: Tue May 18, 2010 1:20 pm
by badmoonrising
If you have a single engine, 2 battery setup, you'll need 2 more battery cables and stainless hardware to mount it.
Here's a diagram:
http://gator49.hostgator.com/~zeromyst/ ... NS1%29.pdf
Re: Easy Wiring for a Perko Switch
Posted: Tue May 18, 2010 2:16 pm
by Heatman
Mine is wired just like diagram #1 in BMR's post. Here's a picture of mine. I made the little panel to mount it too out of some aluminum angle and a 1"x6".
You run the red (+) from both batteries to the switch and also positive lead from the motor. Then just a cable to connect the ground from 2nd battery to the 1st.
