Page 1 of 1

Center Toon Questions

Posted: Wed Jun 30, 2010 8:34 pm
by FloterBoter
Those of you who bought tritoons or added a log:

1. How much larger is the diameter of the center log than the side logs?

2. How many inches lower is the bottom of the center log than the side logs?

3. To get rid of butt-in-the-water syndrome, I assume best to remove the glide thingamajig and run the center log all the way near the back--how far from the lower unit to avoid flow issues?

Not sure who made the boat.

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 5:35 am
by stickman
On my Premier with PTX package, the center toon is listed as 36" (U-shaped) and the outside toons are listed as 27". You may or may not be able to tell in this pic, but the bottom of all three toons are just about even. The center toon has a 12" flat "planing surface" that the boat comes up on (and you can really notice it), while the two outside toons are round with inside lifting strakes, but if I were to put a straightedge across all toons, I doubt there is much difference overall.

Please excuse the yellow rope in the picture. I had to store the boat outside this past winter and I had fashioned a cover from one of those temporary carport thingies, and had it tied to the boat and to a temporary fence post at the windward end of the boat at the time the pic was taken.

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 9:25 am
by dockholiday
All three are same dia, the middle toon is about 4ft shorter. strake inside an out on all toons.
doc

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 10:00 am
by JohnO
outer tubes 23"
Center tube 27" and set 5" lower.
Strakes on all six sides.

center tube about 1 foot longer (in front) than side tubes and extends back to integrated transom

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 10:42 am
by FloterBoter
great info, thanks for the quick replies!

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 2:25 pm
by trott46
all toons the same size 26" and set level. center toon starts a foot after the outer toons and stops about a foot shorter then the outer toons then has the transom strakes on the inside of the outer toons and on the center toon

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 3:30 pm
by toondog
I don't have a clue. :biggrin2

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 8:49 pm
by BassFrequency
all 23" dia. outer tubes 26' center tube 12' with strakes - 5" above outer logs

Re: Center Toon Questions

Posted: Thu Jul 01, 2010 10:29 pm
by FloterBoter
wow, there sure is a lot of variation.

hey bassfreq, is your short center log (geesh that sounds personal) mounted back as far as possible? is the idea to raise the hind end?

Re: Center Toon Questions

Posted: Fri Jul 02, 2010 5:01 am
by BassFrequency
FloterBoter wrote:wow, there sure is a lot of variation.

hey bassfreq, is your short center log (geesh that sounds personal) mounted back as far as possible? is the idea to raise the hind end?

nope, its behind the outers by only 2'

keeps it from submarining

Re: Center Toon Questions

Posted: Fri Jul 02, 2010 8:29 am
by MrGadget
26" outboard, 29" center.
All even across the stern, center ends in transom and is 3" deeper in the water.

Image