Guide on bunks for trailer

You know the drill..

Moderators: Redneck_Randy, badmoonrising, lakerunner

Post Reply
Message
Author
bigwalleye
Posts: 39
Joined: Sat Oct 31, 2009 9:30 am
Location: Brandon Manitoba

Guide on bunks for trailer

#1 Post by bigwalleye » Mon Jul 12, 2010 7:36 pm

Tried scanning some pics my sister ended up taking of me placing the toon on the trailer but the darn scanner is not working. Anyway I wanted to know if I am placing my trailer to far in as the back of the guide on bunks are slightly in the water. Are they suppose to be? On a couple of occasions I have been riding on the left bunk before it corrects itself. This has resulted in one tear in the bunk carpet which I repaired but once again this past weekend I marked it again with out tearing it. For the ones that have bunk guide on for your trailers do you actually back your in until water is slight on top of the bunk? Damn hard to explain without pics. :? :? :?

bigwalleye
Posts: 39
Joined: Sat Oct 31, 2009 9:30 am
Location: Brandon Manitoba

Re: Guide on bunks for trailer

#2 Post by bigwalleye » Mon Jul 12, 2010 7:47 pm

Never mind the scanner I took a pic of the pic :thumbsup :thumbsup Poor quality but better then nothing. Okay am I backing in to far. Remember no issues loading except for riding on the top of the left bunk. Left meaning pontoon facing trailer. Look forward to your replies.

Image
Image
Image

User avatar
Russ
Posts: 34
Joined: Fri Jun 11, 2010 1:37 pm
Location: Lawrenceville, GA
Contact:

Re: Guide on bunks for trailer

#3 Post by Russ » Tue Jul 13, 2010 11:20 am

If it were me doing it, I would have the trailer back in the water more than you have it, so I would say compared to the way I do it you're not in far enough. It mostly comes down to the ramp you're at, how steep it is, how far back it goes, etc... I've also seen quite a few people afraid to go back far enough and they either end up revving their engines to max trying to get the boat on the trailer, or about ripping the hook off the front trying to drag the boat up onto the trailer with the winch.

When I launch my pontoon, my bunks go completely under water, and the back tires of my 4-runner are about 2 feet back into the water.

When I put it back on the trailer, I first back the bunks all the way under to get them wet, and then pull back out so about 1 foot length of the front of the bunks are out of the water. This leaves my rear tires of my 4-runner either right at or just in front of the water line.

Everyone has their own ways to do it, but in my opinion, there should be little effort by either the engine or the winch to get the boat all the way up on the trailer, that's how you know you're back far enough.
-Russ


-------------------------------------------------------
2000 Party Barge 18' w/ 2000 Merc 50 2-stroke
Pulled by 1999 Toyota 4Runner 4x4

User avatar
lakerunner
Site Moderator
Posts: 4820
Joined: Fri Mar 17, 2006 2:31 pm
Location: Live in McAlester, Ok Boat on Tenkiller
Contact:

Re: Guide on bunks for trailer

#4 Post by lakerunner » Tue Jul 13, 2010 11:27 am

We sink about a foot more
Loyd & Betty Meeks
Livin the lake life
2004 Tracker 22 Regency/2010 90 E-Tec. Pulled by Ford 2020 F 250,
McAlester, Oklahoma
Home lake is Tenkiller

Post Reply