Transom ideas

You know the drill..

Moderators: Redneck_Randy, badmoonrising, lakerunner

Message
Author
User avatar
GregF
Posts: 3323
Joined: Thu Aug 26, 2010 8:47 pm
Location: Estero Florida

Re: Transom ideas

#16 Post by GregF » Thu Aug 09, 2012 2:31 am

When a motor goes in running the concern is that it stop before it ingests a cylinder of water. That will break pistons and rods. Those race boats may have kill switches.
I bet a new 4 stroke would fare better than a 2 stroke submerged (off) because the crank case is fairly well sealed on new motors. You still need to treat it very fast when it comes out. As soon as the air hits it, rust starts.
WD40 to the rescue!
1974 Harris
70 HP 4 stroke EFI Yamaha

User avatar
rancherlee
Posts: 580
Joined: Tue Jul 13, 2010 5:59 am
Location: Eveleth MN

Re: Transom ideas

#17 Post by rancherlee » Thu Aug 09, 2012 4:02 am

sunk a few snowmobiles "water skipping" in the summer and also sunk a few ATV's mudding also. As soon as its out of the water you drain the water out, fill the entire crankcase with Diesel for bit, turn the engine over by hand a few revolutions then drain and fill with oil. Diesel does a great job of driving water out, getting in every nook and cranny, and acting like a lube. After an oil change or two she should be good to go.
1988' Kennedy 20' "Haley's Comet"
Rebuilt 2016 with 25" single strake outer tubes and a 25x23" straked U-tube
2003 Suzuki DF140 - Yamaha 9.9HT kicker - 39.1@6300rpm

Post Reply